Meeting 2-20-09

Attendence- Kevin, Ian

Agenda- Finish polycarb, Paint, mount Prototype Board

kevin: first we bent and drilled the polycarb. Then when we got to Ian's we painted it and finished some more of the detail work. Later we soldered the LEDs for the protoboard. We continued to make the team tee-shirts.

Meeting 2-19-08

Attendence- Ian, Kevin

Agenda- Cut and bend polycarb

I cut out the polycarb and started bending it.  i didn't have time to finish it though.-  Ian

I worked mainly on code but helped Ian with the bending.  -Kevin

Meeting 2-18-09

Attendence- Ian, Kevin, Tucker

Agenda- Arm Reinforcement, Polycarb.

i marked the polycarb to be cut.  -Kevin

I worked on reinforcing the arms with Tucker.  -Ian

Meeting 2-17-09

Attendence- Ian, Kevin, Penelope

Agenda- Finish gearing, test arm, build polycarb

We finished the gearing and tested the arm, but we didn't have time to do the polycarb.  -Ian

meeting 2-16-09

Attendence- Ian, Tucker, Kevin, Jared

Agenda- Finish the gearing, re-wire the servos, re-gear upper arm, test, make polycarb cutouts on paper

I worked on the arm gearing, rewired the servos for the bucket and worked on one of the polycarb sides.  -Tucker

I worked on the polycarb and upper arm gearing, and tested the arm.  -Ian

Meeting 2-13-09

Attendence-Ian, Jared, Penelope, Nick

I found out that the gearing on the lower arm is too high, so we are going to try and remount it to a 6-to-1 gear ratio.  -Ian

I worked with Ian to find a way to remount the lower arm motor so it doesn't kill itself. -Nick

Meeting 2-10-09

Attendence- Ian, Tucker, Penelope

Agenda- Swap out broken pieces, fix code, test arms

Turns out the tubes need clamps on both ends so they don't slip out of the clamps.  Which means that before we can test the arms we have to remove the tubes and put tube clamps in the ends.  -Ian

I helped Ian remove the tubes to fit clamps in them and tried not to lose anything, even though i mostly helped FRC.